QSC’s RMX 5050 power amplifier
represents the state-of-the-art in professional quality performance at
an affordable price. Perfectly suited for a wide range of sound
reinforcement applications including professional touring, performing
musicians, and mobile entertainers, the RMX 5050 is optimized to deliver
high levels of sustained power, extraordinary audio performance and
road-proven reliability.
Like its smaller sibling (the RMX 4050HD), the RMX 5050 features a
three-tier, Class H design. The RMX 5050 is extremely efficient at real
world power levels. Less AC current is wasted and more goes into
producing useful audio power. The RMX 5050 uses the best available
component upgrades to increase peak power by 25% over the RMX 4050HD.
Like all RMX amps, the RMX 5050 features balanced 1/4 in. TRS, XLR and
barrier strip inputs, binding posts and Neutrik Speakon™ outputs,
front-mounted gain controls, plus signal and clip LED indicators to
monitor performance.
Features
The new flagship of the RMX line, the RMX 5050 provides extremely high
power and represents tremendous value
The RMX 5050 provides advanced thermal performance, delivering higher
continuous power in 2-ohms stereo or 4-ohms bridged applications
Dual mono, high current power supply for increased reliability and
performance
3RU chassis only 16 in. deep
Professional quality performance—incorporates road-proven QSC designs
High-current toroidal transformers for greater two-ohm power and low
noise
Independent user-defeatable clip limiters reduce distortion
Selectable low-frequency filters (30 Hz or 50 Hz) protect speakers and
increase headroom
Balanced 1/4" (6.3 mm) TRS, XLR, and barrier strip inputs for maximum
flexibility
Binding post and Neutrik Speakon™ outputs
Front mounted gain controls for easy access
Signal and Clip LED indicators to monitor performance
3-year warranty.
Technical Description
Stereo Mode, Both Channels Driven
8 ohms (FTC 20 Hz-20 kHz 0.1% THD): 1050 Watts
4 ohms (FTC 20 Hz-20 kHz 0.1% THD): 1600 Watts
2 ohms (FTC 20 Hz-20 kHz 0.1% THD): 2000 Watts
8 ohms (EIA 1 kHz 0.1% THD): 1100 Watts
4 ohms (EIA 1 kHz 0.1% THD): 1800 Watts
2 ohms (EIA 1 kHz 1% THD): 2500 Watts
Bridge-Mono Mode
8 ohms (FTC 20 Hz-20 kHz 0.1% THD): 3200 Watts
8 ohms (EIA 1 kHz 0.1% THD): 3600 Watts
4 ohms (EIA 1 kHz 1% THD): 5000 Watts
Distortion (SMPTE-IM) Less than 0.02%
Distortion (Typical)
20 Hz-20 kHz: 10 dB below rated power: Less than 0.02%
1 kHz and below: full rated power: Less than 0.02%
Frequency Response: 20 Hz to 20 kHz, 8 ohms, LF filter bypassed, +0/-1
dB
5 Hz to 50 kHz, 8 ohms, LF filter bypassed, +0/-3 dB
Damping Factor: Greater than 250 @ 8 ohm
Noise (unweighted): 100 dB below rated output (20 Hz to 20 kHz, 8 ohm
load)
Input Sensitivity: 1.42 Vrms for 1050 watts into 8 ohms
Controls Front: AC power switch, Ch. 1 and Ch. 2 gain control
Controls Rear: 10-pole DIP switch featuring LF filter on/off, LF filter
30/50 Hz, Clip Limiter on/off controls for each channel and switches for
selecting Stereo, Parallel, or Bridge mode. Push-button circuit breaker
for each channel.
Voltage Gain: 64x (36 dB) for 8 ohm load
Input Impedance: 20 k ohm balanced, 10 k ohm unbalanced
Indicators
Power-On: Green LED, Protect: Red LED
Signal -30dB: Yellow LED, Clip: Red LED
Connectors Input: XLR female, TRS (1/4-inch), and barrier-strip screw
terminals, each channel
Connectors Output: Binding posts and Speakon outputs (Ch. 1 Speakon
wired for biamp)
Cooling: Continuously variable-speed fan, rear-to-front air flow
Amplifier Protection: Short circuit, open circuit, thermal, ultrasonic,
and RF protection. Stable into reactive or mismatched loads
Load Protection: On/off muting, DC fault output crowbar
Power Requirements: 100, 120 or 240 Volts AC (±10%) 50-60 Hz (factory
configured)120V models require 20 Amp, 120V service and are supplied
with a NEMA 5-20 plug on the cordset.
Dimensions (W x H x D): 19.0 x 5.25 x 15.9 in. (48.3 x 13.3 x 40.39 cm)
Weight: 75 lb (34.02 kg) net, 87 lb (39.46 kg) shipping
3-year warranty plus 3-year extended service contract All of our
QSC products are listed at MAP (the lowest price that the merchandise
can legally be sold for). QSC does NOT honor any warranties
from customers who purchased their equipment from a dealer with prices
below MAP.
$275 Rebate - Click
here for details
Regular Price: $2,999.99
Our Price: $1,599.00 (FREE shipping within the 48 states) |
